Page tree
Skip to end of metadata
Go to start of metadata

REAR SUSPENSION, AXLE SHAFTS

Use wheel bearing tool to remove old bearing and install new bearing following tool manufacturer's instructions.

  • Remainder of installation is reverse of removal. Bleed brakes as described in 470 Brakes-Hydraulic.
Tightening torques
  • Brake caliper to trailing arm (M12)..........60 Nm (43 ft-lb)
  • Brake hose to brake line..........12 Nm (9 ft-lb)
  • Brake rotor to wheel hub (M6)..........5 Nm (44 in-lb)
  • CV joint to transmission flange
    M8 bolt..........42 Nm (30 ft-lb)
    M10 bolt..........83 Nm (60 ft-lb)
  • Rear shock absorber to trailing arm (M14)..........125 Nm (92 ft-lb)
  • Stub axle shaft to hub
    M20 castellated nut..........300 - 320 Nm (217 - 231 ft-lb)
  • Wheel bearing cover plate
    to bearing housing (M8)..........25 Nm (18 ft-lb)
  • Wheel to wheel hub..........130 Nm (96 ft-lb)

Before Performing any Work

Please read Cautions and Warnings before proceeding with any work on your vehicle

Technical Discussion Forums

Error rendering macro 'rss'

java.net.ConnectException: Connection refused: connect

more...

Subscribe to RSS feed

Permalink
Wheel brearing cover plate tightening torque correction - page 420-20 (P983) https://wiki.bentleypublishers.com/x/MwDF

Log in