Page tree

Versions Compared

Key

  • This line was added.
  • This line was removed.
  • Formatting was changed.
Comment: Migrated to Confluence 5.3

Abstract: Air Filter, Removing - 2004 Boxster S Special Edition


Applies to: 2004 Boxster S Special Edition - North American market


Info
User submitted update
User submitted update

The following tech article was submitted by Stan G. of Cupertino, CA on October 23, 2008.

Section
Column
width215px
 
Column
Air filter, replacing (2004 Porsche Boxster S, Special Edition)
Section
Column
width215px

Column

Partially lower convertible top so that gap between top edge and the windshield trim is about 16 in.

– Detach top tension cable at rear on each side.

Section
Column
width215px

Column

Unclip fabric covering on both sides of top to access hook-and-loop strap. Pull strap forward and attach to convertible top guide (to hold rear window up and out of the way) (arrow).

– Remove storage box.

– Remove carpet covering.

– Remove engine compartment lid.

Section
Column
width215px

Column

Working on driver's side of engine compartment, remove two air filter cover screws (arrows).

– Remove air filter cover.

Section
Column
width215px

Column

Remove single screw holding air filter in place (arrow).

– Push filter forward to release from air distribution inlet.

Section
Column
width215px

Column

Maneuver filter carefully from filter housing.

Section
Column
width215px

Column

With filter removed from, remove single screw from filter end cap.

Section
Column
width215px

Column

Press filter locking tabs together (two sets of tabs) and pull filter end cap loose.

Section
Column
width215px

Column

Press end cap onto new filter and attach screw.

Section
Column
width215px

Column

Carefully maneuver new filter/end cap assembly into housing. Be sure new filter is securely pushed back onto air distribution inlet.

Info
titleAuthor's Note

The above step is the toughest part in the whole procedure, so prepare to be patient, especially the first time you do this.

– Secure air filter assembly with screw that holds end cap to filter housing.

– Attach filter housing cover using two screws.

– Reassemble engine cover, carpet, storage box, and convertible top in reverse order of disassembly.

Warning
titleBefore Performing any Work

Please read Cautions and Warnings before proceeding with any work on your vehicle

Panel
borderColor#999
bgColor#fff
titleBGColor#ddd
titleRelated Technical Manuals

More Porsche products...

Panel
borderColor#999
bgColor#fff
titleBGColor#ddd
titleTechnical Discussion Forums
RSS Feed
titleBarfalse
max5
showTitlesOnlytrue
urlhttp://tech.bentleypublishers.com/rss/rssthreads.jspa?forumID=85

more...

Subscribe to RSS feed

Log in