Page tree

Motronic fuel injection and ignition system, component layout, AAH engine, MMN 100/200

Engine Control Module (ECM) -J192-

– Not shown
– Located in passenger-side footwell, in electronics box under carpeting

  1. Harness connectors for:
    1. Oxygen Sensor (O2S) heater -Z19-
      • Heater for heated oxygen sensor -G39-, right bank
      • Black 2-pin connector
    2. Ignition coils
      • Battery positive voltage (B+) supply
      • White connector
    3. Heated Oxygen Sensor (HO2S) -G39-
      • Signal wire
      • Under connector holder on bulkhead
    4. Knock Sensor (KS) 1 -G61-
      • Blue connector
    5. For Engine Speed (RPM) sensor -G28-
      • Gray connector
  2. Power Output Stage -N122-
    • For ignition coils
      1. Signal wires
        • From Engine Control Module (ECM)
        • Brown 4-pin connector
      2. Ignition coil primary circuit connections
  3. Throttle Position (TP) sensor -G69-
  4. Connectors for:
    1. For Heated Oxygen Sensor 2 -G108-
      • Signal wire
    2. Oxygen Sensor (O2S) 2 heater -Z28-
      • Heater for heated oxygen sensor 2 -G108-, left bank
      • Black 2-pin connector
    3. Knock Sensor (KS) 2 -G66-
      • Blue connector
  5. EGR temperature sensor -G98-
    • US vehicles only
  6. Camshaft Position (CMP) sensor -G40-
  7. Data Link Connector (DLC)

Before Performing any Work

Icon

Please read Cautions and Warnings before proceeding with any work on your vehicle

Permalink
1992 Audi 100 camshaft position sensor location https://wiki.bentleypublishers.com/x/CAC3

Log in